Note: Due to the precision required to get a good corner on a carbide end mill a very accurate motor shaft is required so that the run out at the profile of the wheel is minimal. A high accuracy Tradesman motor shaft, set up in the factory, is recommended – add $200 USD)
California Proposition 65 Warning
WARNING: This product may contain materials and/or chemicals such as arsenic, lead, and others that are known by the state of California to cause cancer and/or reproductive problems.For more information, visit www.P65Warnings.ca.gov
Paiement & Sécurité
Modes de paiement
Vos informations de paiement sont gérées de manière sécurisée. Nous ne stockons ni ne pouvons récupérer votre numéro de carte bancaire.
Sécurité
Estimer l'expédition
Description
Grinding wheel with profiled radius for quickly corner prepping end mills
- Designed to quickly produce a corner radius without the use of the Radius Attachment
- Also good for neck reduction using the flat of the outside of the wheel
- Three options: Choose 0.020" and 0.040"rads, 0.030" and 0.060" rads, or 0.090" and 0.120" rads
- Use on any tool grinder with a 1-1/4" hub
- 1-1/4" arbor
- 6" Diameter
- Diamond
- 200 grit
- Prolong the life of your carbide end mills by removing the brittle corner
